Snorer's Friend Singapore - Fix Snoring fast and get on with your life!

Singapore top selling product. * Made in Australia * Free Shipping *

Introduction

The Snorer's Friend® is a Mandibular Advancement Device designed to stop the noise of snoring. It is made from a soft thermoplastic material and intended for custom-fitting by the user in their own home.

This device is designed for healthy adults who wish to reduce the volume and frequency of their snoring. It is not suitable for children, people with a history of epilepsy, people with certain tooth or gum problems, or people with obstructive sleep apnoea (except under the supervision of a doctor or dentist, see below).

If you do not have a full and healthy set of teeth, you may still be able to use the Snorer's Friend®, but you must consult a dentist, doctor or the manufacturer for special precautions to follow before starting use.

Some topical medications, lotions or pastes may react with the material of the device, so you must not use the device on nights when you apply any other product to your mouth.

Check out our website at http://www.stopthatsnoring.com.sg for more information. 

How it work?

When you wear the device your tongue is held slightly forward, because it is connected to your jaw. This helps keep your airway open, by increasing the clearance between the back of your tongue and the back of your throat. Lack of clearance in that area is the source of most snoring noise.

How to use 

1.    Wash the mouthpiece under running water

2.    Place the mouthpiece in a bowl

3.    Pour hot boiling water over the mouthpiece. Make sure it is fully submerged.

4.    After 15 -18  seconds remove mouthpiece with tongs. Keeping the mouthpiece in the hot water any longer may over- soften and  cause it to become misshapen.

5.    Insert the mouthpiece into mouth. Note that one side of mouthpiece is shaped HIGHER. Place this side over TOP row of teeth.

6.    Bite down for ½ minute to leave an impression and to ensure the mould is shaped to fit your mouth. Press front flat piece against teeth to create tighter fit. Do NOT bite down too hard so as to cut through the soft malleable plastic.

7.    Repeat boil and bite process can be repeated to get the right comfortable fit.

8.    Snorer's Friend is now ready to use.

9.    To clean, simply wash under running water after each use.