Parents who pay attention， because of a relatively heavy jack 3 kg or so， plus a 3.5 kg box packaging， the road courier throw beat fight， Jack will be out some paint surface a little， oh， but definitely does not affect the results， here will try to pick a good package good， hope a lot of understanding about the mind of the pro ~ ~ If you do not take this section baby， oh， thank you very much for supporting us.

Name: 5T jack

Height: 17CM around

After stretched height (30CM) head spin up is 35cm

The existence of different measurement ·· 1-2 cm error is normal ··

Here is the relevant operational requirements， before using the jack to peruse， thank you!

Parents who receive the test when ·· Air is certainly not rise to top oh ··

1. If the fuel pump is insufficient， the need to first join the working oil pump (hydraulic oil) to work.

2. It is estimated from the weight， avoid overloading use.

3. Determine the focus of lifting objects， select the jack focal point， and must take into account whether the hardness of the ground pad with tough wood， in order to avoid the risk of dumping of produce when lifting.

4. Jack the heavy lifting， the heavy support firmly prohibit the jack should be used as support with tough wood， in order to avoid load is not balanced， the risk of dumping of produce.

Caption specific methods of operation:

Lifting:

1. Turn the jack handle clockwise

2. Place the jack is placed right below the lifting vehicle parts (such as the need to rotate the adjusting screw counterclockwise until it contacts the vehicle on jack)

3. Insert the jack handle into the handle casing， the vertical actuator handle until the desired height of the vehicle rises

Drop: Caution: vehicle slowly declining slowly rotating back to the oil valve

1. Remove the handle， with the handle is released back to the oil valve， (please slowly turn the handle counterclockwise to release the oil return valve) Note: Do not loosen the oil return valve over two laps;

2. After the vehicle is completely down， move the jack. (If the adjustment screw in YANSHENG state， you need to rotate clockwise until it is completely out of their vehicles)

Note:

a) When a load， avoid the quick connector removed， in order to avoid accidents and damage to the parts.

b) This machine is oil as the medium， this equipment must be prepared oil and maintenance work， in order to avoid blockage or leakage affect the results.

c) a new or long set of hydraulic jacks， because there is more air cylinders memory， when started， the rod may appear tiny breakaway phenomenon can be reciprocating hydraulic jack load 2-3 times to exclude cavity air. Long idle jack， do not work long-term because of the seal and cause hardening of the seal， thus affecting the life of hydraulic jacks， hydraulic jack when not in use so a month to load reciprocating hydraulic jacks 2-3 .

Maintenance:

    Oiling / lubricants:

1. Place the jack placed in an upright position;

2. Lower the pump and piston position， until it is completely relaxed state;

3. Remove the rubber drain plug jack;

4. Note the injection of quality hydraulic oil (up to live with a hole under the bottom) side;

5. Replace the rubber drain plug;

6. Periodically lubricate joints and drive at the adjusting screw.