1、Enegry saving， low heat and long service life

2、Suitable for deco

Warranty: Two years

Adhesive back tape?

16 color changing

With 24 key IR remote

Lighting modes: Flash， Strobe， Fade， and Smooth?

Color: multicolor

Working current: 0.6A

Working temperature: -20° to 50°

Note: Please do not cover the receiver when using.

If the remote controller's color does not match with the light's color， please operate according to the following instructions:?

1. Turn the light off by ON/OFF key of the remote controller .?

2. Place the remote controller towards the signal receiving port of the controller and press the key on the lower right corner( 24 keys remote controller: Please press "SMOOTH" key. 44 keys remote controller: Please press "FADE7" key ). If the strip light flashes， it indicates successful adjustment.?

3. Turn the light on by ON/OFF key of the remote controller and observe whether the lighting color is matched with the remote controller's color. If the lighting color is still not matched with the remote controller's color， then repeat the steps above until the color is matched(6 times for a cycle).?

Note: There are positive and negative pole on the 4PIN joint of the strip light. Wrong wiring will lead to strip light not being bright or the lighting color being unable to adjust. Pay attention to the installation direction and there is a direction indicator on the plastic terminal.