The WLXY WL-3015 Desoldering Braid Solder Wick is finely braided from high quality copper wire and comes in a roll. It allows you to easily and thoroughly remove the extra solder from components or pads on the circuit board without causing any damage or component removal. Hence, it is widely used in the rework and repair of printed circuit boards, computers, cellphones or other electronics. A variety of width options are available to suit your needs. Don't hesitate to get one!
FEATURES
Finely braided from high quality copper wire, come in a roll
Allow you to easily and thoroughly remove the extra solder from components or pads on the circuit board
Won't cause any damage to the board or remove the onboard component
Widely used in the rework and repair of printed circuit boards, computers, cellphones or other electronics
Easy to use
A variety of width options are available to suit your needs How to use:
Place the desoldering wick over the solder to be removed, then push the heated soldering iron tip onto the desoldering wick and the solder will be absorbed
Remove the desoldering wick after the solder has been absorbed
Cut off the used section of the wick
Repeat steps 1, 2, 3 if the solder is not removed completely (absorbability may differ depending on the type of solder) Caution: Do not force the tip against the desoldering wick to avoid injury to yourself or damage to the parts and PCB Do not heat the desoldering wick for more than 5 seconds to avoid damage to the parts and PCB
Specifications
Brand
WLXY
Model
WL-3015
Material
Copper Wire
Color
Coppery
Length
1.5m
Width
3.0mm
Dimensions
(59.05 x 0.12 x 0.12)" / (150 x 0.3 x 0.3)cm (L x W x H)