How to use this product

1.Plug the adapter.

2.Press the wire feed button, then the pin will start preheating. If the indicator is red in green, it means the temperature reaches the melting point.

3.Put ABS filament in the import hole, hold the Feed button, the thread will be sent into the hole of the inner motor.
If to allow the thread from the nozzle to draw what you want.

4.Press the speed swtich, you can freely change the output speed of the filament.

5.Hold the wire eject button may automatically withdraw the thread.

Special Note:

If in the filament hole to feed the filament or fall out, make sure the speed button switches to high speed, so that the filament move smoothly.
And remember to after retraction of the thread to cut the end of the filament neatly out of the hole.
The painting pen tip and the area are close to the high temperature range, the highest temperature can reach 230 degrees, do not touch the tip to touch with your hands or other objects with the pen.

Package included:

1 x 3D Printing Pen ABS or PLA Straight (Circle) Filaments