Made in the USA
Compatible with all foams
Dries crystal clear
Overnight cure for full strength
Proud Sponsors of Wounded Warrior Project

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 3.8 inch
Height : 1.7 inch
Length : 8.1 inch

Item Weight: 4.96 ounce (View shipping rates and policies)
Shipping Weight: 5.6 ounce (View shipping rates and policies)

ASIN : B011XWDTOW

Product Description

FOAM-CURE is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours. FOAM-CURE works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner. Directions in 5 different languages.