It is relatively simple to wire up the RAMPS. Just add the extruder heating coil wire to D10， the thermistor to the two T0 pins on middle right right， and wire up the steppers and endstops. From left to right， wire all of the stepper motor\'s wires as red， blue， green， and black or red， green， yellow， blue into the pins next to the Pololus. When you connect the wires to the endstops (if you are using 3 endstops， plug them into the MIN (-) slots)， make sure you match the labels.
| geeetech Reprap Ramps V1.4 smart 2004 20*4 LCD Display controller with adapter 3D printer free shipping geeetech US$ 18.91/piece
|
| 2pcs/lot 3D printer smart controller RAMPS1.4 LCD 12864 LCD control panel US$ 28.12/lot
pieces / lot |
| Mega 2560 R3 + 1pcs RAMPS 1.4 Controller + 5pcs A4988 Stepper Driver Module RAMPS 1.4 KIT for 3D Printer kit Reprap MendelPrusa US$ 24.02/piece
|
| RAMPS1.4 LCD 12864 LCD control panel 3D printer smart controller Free shipping Drop shipping US$ 14.52/piece
|
| 5pcs/lot RAMPS 1.4 3D printer control panel printer Control Reprap MendelPrusa free shipping drop shipping US$ 36.15/lot
pieces / lot |
| Mega 2560 R3 + RAMPS 1.4 Controller + 5pcs A4988 Stepper Driver Module+RAMPS 1.4 2004 LCD control/+14pcs dupont cable US$ 40.09/piece
|
| Free ship!ramps kit=Ramps 1.4 SD ramps MK2B Mega2560 R3/2G memory card Cooler Fan/A4988 / Endstop etc.For 3D Printer kit RepRap US$ 50.52/set
|
| New 3D Printer Kit RAMPS + 2004 LCD Controller + MEGA 2560 R3 + A4988 Driver US$ 34.78/piece
|
