Titan-Magnetics Mounting Magnets (a.k.a. Pot Magnets) are Neodymium strong magnets set within a metal “pot”

Mounting magnets with a center hole design are great for screw on to furniture, fixture or light weight items which can be attached to metal surfaces.

The metal casing provides 2 important enhancements to neodymium magnets:
1) It makes the neodymium magnets more durable and less likely to break should it snap on to another neodymium magnet or metal surface.

2) It increases the magnetic pull strength of the exposed side by directing some of the magnetic field from the opposite side to the flat exposed side.

Mounting magnets are available in 3 sizes with varing magnetic strength, estimated when it's attached upside down position (horizontally on metal ceiling/beam).
*Note: Sideways (vertically on metal wall) load is approximately 1/3 of the horizontal position eg. if max load upside down is 25kg, sideways load is appx. 8kg before it start sliding or drop.


Dia. 16mm (Small)
Hold up to 600g upside down*

These smallest size pot magnet are safe to handle with bare hands. Suitable for small or very light weight items.
The 4 pcs are all in the same polarity, hence they will not align perfectly on the flat side.



Dia. 25mm (Medium)
Hold up to 8kg upside down*
Facing pairs

These medium size mounting magnets with just an increase of 9mm in diameter from the smallest dia.16mm size give it an astonishing jump to 8kg max. load. More than 13x the load of the dia. 16mm mounting magnets.

Be careful when handling as it can snap a nasty pinch on unsuspecting fingers and cause serious injury.



- Dia. 32mm (Large)
Hold up to 20kg upside down*
Facing pairs

These large size dia. 32mm mounting magnet should be handled with care as it can snap a nasty pinch on unsuspecting fingers and cause serious injury.

With an increase of 7mm in diameter, the load increase by additional 12kg.