Amazing GOOP Anti-Skid Epoxy provides a hard, flat, textured finish that helps avoid slip and fall accidents. It can be used indoors and outdoors in areas where water is present or slippery conditions exist. Anti-Skid Epoxy is friendly on bare feet. Its formula is lead-free and chemical, gas and oil resistant.

Use Anti-Skid on: 
• Stairs, ladders and walkways
• Porches and decks 
• Ramps and patios 
• Boats: Decks, bow and ladders
• Trailers 
• Docks: Marina and loading areas
• Pools: Decks, ladders and diving boards
• Floors: Basement and garage
• Hydraulic and forklift equipment

INSTRUCTIONS FOR SAFE USE

Follow these step-by-step directions when using Amazing GOOP Anti-Skid Epoxy:

1. Surface should be dry, clean and free of oil, wax, dirt, loose paint and other contaminants. If necessary, remove all the old paint down to the original surface. Aluminum surfaces should be treated first before applying Anti-Skid. Wood surfaces should be primed with an oil based primer. Test a small area for color compatibility and adhesion. 
2. For best results, spray between 70 and 90 °F (21 and 32 °C). Applying Anti-Skid Epoxy below 50 °F (10 °C) will cause the paint to spray or dry improperly. 
3. Mix contents of can well by shaking for 2-3 minutes. Mixing ball will roll freely when properly mixed. Continue to shake can intermittently for 10 seconds during use. 
4. To apply, spray in a sweeping motion 12 to 15 inches away from surface. 
5. IMPORTANT: Clean valve immediately after each use. Hold can upside down and spray until only clear gas comes out (3-5 seconds). If spray valve becomes clogged, pull off and clean in lacquer thinner. 
6. Overspray can be removed with paint or lacquer thinner.

• Use on surfaces such as wood, metal, fiberglass, tile, porcelain and more 
• Resists water, chemicals, gas and oil 
• Dry to touch in 10 to 20 minutes at 77° F / 25° C and dries completely in 24 hours

Color : Clear / Transparent