u0026nbsp;
Description
Product description:u0026nbsp;
1. This product is for the purpose of decoration, only for the decoration of cars, there is no real air into the function.
2. Most of the product itself is made of hard resin, and can not be installed to the curved surface, hood, etc. In the realization of a good location to confirm the basis of the purchase.
Installation steps:
1. Before installation, the body and the car surface with to confirm the installation location.
2. At this point, decorate the inside of the wind network itself (double-sided adhesive part) as a whole, find the grounding (see whether the arc).
3. If the bending of the body to install the site, if there is not enough damage to the goods and then the intensity, there will be goods off situation.
4. When installing the door or near the door, be sure to switch the door to confirm in advance to ensure that no contact.After the mounting position is set, the protective film and the vehicle body are properly marked.
Precautions:
1. This product is not heat-resistant, so please do not like the hood in the heat of the place to use.
2. If the coating surface of the secondary coating vehicle is weak, the vehicle body may be damaged if the surface is very weak.
3. Depending on the use of this product will fall off the situation, please pay full attention.
4.to stand for a long time the body of the product opened, according to the sound of the burning car, the goods will be left in the car marks.
5. Long time in the sun exposure, there will be plating off, discoloration, surface cracks.
6. Bonding intensity is very strong, can not be re-opened after a paste paste. If the product is opened, the adhesive tape may be damaged or the adhesive surface may be damaged.
7. The Company will not be liable for any damage, deterioration, or damage to the vehicle or the product after installation or removal.
8. Keep out of the reach of small children.
u0026nbsp;
u0026nbsp;
Details Display
