Brief introduction

RAMPS 1.4 3D printer control panel printer Control Reprap MendelPrusa

This list is Pololu trillion rupiah or ramps shorter. It was designed as a low-cost small package RepRap needs to fit the entire electronics . Oblique interface with the powerful Arduino MEGA platform Arduino Mega and have plenty of room for expansion. In the stepper drives and an Arduino MEGA shield extruder control electronics for easy maintenance replacement parts upgrades capacity and expandable modular design includes plug-ins. In addition some Arduino expansion boards can be added to the system as long as the main ramp plate is saved to the top of the stack .

This board is mainly based on the Pololu_Electronics and work Tonok Adrian 's . Copper etching anti- Vick recommended method . Vick also by the work of EasyDrivers inspiration. Circuit design mainly based on the provision of initial Adrian'sPololu_Electronics Joaz RepRapSource.com pin definitions and many design improvements. Too much inspiration advice and from Prusajr Kliment Maxbots Rick and many other RepRap community ideas.

Feature
1 It has Cartesian robot and the requirements of the extruder .
(2) extended to control other accessories.
3 heater / fan output and three thermistor circuit MOSFET.
4 fusion 5A additional safety and component protection
5 heating control extra bed 11A fuse
6 Suitable for 5 Pololu stepper driver board
7.Pololu board pin socket so they can be easily replaced or removed for future designs .
8.I2C and SPI pins left for future expansion.
9 All the MOSFET PWM pin is hooked into versatility .
10 . Servo connector for connection to the end stop block the motor and the light emitting diodes. These connectors are gold-plated rated current of 3A very compact.
11.SD card add - is now available from the Kliment - Sdramps
12.LED indicate when the heater output
13 Option 2 motors connected to the Z Prusa Mendel






Packaging Details
Unit Type: piece Package Weight: 0.082kg (0.18lb.) Package Size: 12cm x 12cm x 8cm (4.72in x 4.72in x 3.15in)