REDCON 2.4G 4CH DMSS Parkfly Receiver DM4F Compatible With JR XG6 XG7 XG8 XG11<br /><br /><br /><br />Description:<br />Brand Name: REDCON<br />Item Name: DM4F receiver<br />Band: 2.4GHz<br />Channel: 4<br />Modulation: DMSS<br />Dimensions (W x Lx H): 19.5x44x10mm<br />Weight: 5g<br />Voltage Range: 3.6-9.6V<br />Antenna Length Main RX: 210mm<br />Compatibility: JR(XG6, XG7, XG8, XG11)<br />Usage: Special for small electric and non-power airplanes and Electrical  Helicopters.<br /><br />Bind Procedure:<br />1. Connect the battery( or BEC\/ ESC with BEC output) to Batt.channel and note the LED on the<br />receiver should flashing, now, the receiver is on bind mode.<br />2. Power on the transmitter, and enter the BIND menu.(Checking manual of your transmitter,how to enter the BIND menu. )<br />3. Press the BIN button on the display. The system will connect within a few seconds. Once connected, the LED on the receiver will go solid, indicating the system is connected.<br />4. Exiting from the BIND menu, and then setting the failsafe according the function of your tansmitter.(Please check failsafe function of your transmitter).<br /><br />Note:<br />DO NOT use it for nitro and large electric airplanes and helicopters.<br />DO NOT stick or apply the receiver antenna to Carbon or Metal material directly, as it willdrastically reduce the operating range.<br />For receivers with multi-antennas, it is recommended that each antenna be applied at 90degrees to each other.<br />For receivers with single antenna, please apply the antenna far away from any carbon, metalor electronic equipment as possible.<br />Make sure turning the transmitter first after binding when using your radio control system.<br />Make sure setting failsafe after binding.<br /><br />Package Included:<br />1x REDCON DM4F receiver