General add-on heated bed power expansion module, compatible with Anet A8 and most 3d printers. Effective to resolve the hot bed power is too large and the load current problems.
EQUIPPED with 32 bit high-speed ARM chip, the heat bed power module can be used in both Chitu motherboard and other open 3D printer motherboards.
If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this PChero heat bed module is recommended.
OFFER PROTECTION- With this add-on module to your controller board, you can lead the maximum current up to 25A. If you need anything greater or equal to 15A this module is a must!
NOTE: Under the premise of normal cooling, it works stably under I(Max)=25A, the current must NOT exceed 25A while in the work process.

Technical Details

Product Details

Package Dimensions
Width : 3.35 inch
Height : 1.38 inch
Length : 3.66 inch

Shipping Weight: 2.08 ounce (View shipping rates and policies)

ASIN : B072MF3ZDD