【Fire (5th generation) exclusive protection film】 Digio 2 liquid crystal protection film High definition anti-reflection bubble-less processing 2 pieces

Features:

  • Protection film designed exclusively for Fire (fifth generation)
  • It is a film that can eliminate the filler causing the glare which is the problem of conventional antireflection film and the sharpness of image quality to be lost and reproduce a clear image.
  • It is a touching feeling as "moist and smooth" by the surface special treatment.
  • Fingerprint resistance, excellent in finger slipping.
  • Maintain the film in a beautiful state for a long time by hard coating processing of the film surface.

Product information:

Shipping Weight: 45 g

Package Dimensions: 0.41 x 14.61 x 24.51 cm

Customer reviews from Japan:

I put it beautifully.

It was 1,350 yen with 2 pieces entered. It is difficult to remnant fingerprint marks with low reflection, and it is easy to wipe dirt. Since the protective seal is divided into 3, it is easy to stick. I used it for FIRE purchased at 3,980 yen at sale, 3,000 yen with case and film ... Although I got lost a little, reflections were suppressed and video and so on became easy to see, I am very satisfied. Since it was reviewed by the company for FIRE 8 HD of the company, it overlaps a part, but the type of the protective film remains, and it was able to stick cleanly without entry of air bubbles. When peeling off the protective sheet in the center, straighten horizontally, if you do not peel gently, the mold may remain on the film side. There are times when bubbles disappear, but bubbles enter if you do not paste correctly. The trick to stick cleanly is to remove dust on the screen more than anything, the dust becomes bubbles. Tissue etc. will call extra dust, so it is good to remove dirt and dust with a hand-tight handkerchief etc., then wipe with the attached nonwoven fabric. If you have an air spray, it is good to skip the dust with it, and if there is an old seat stick it to it and remove dust is also good. I think that it is easier to peel off the center part first, then paste it outwards to the upper part and the lower part. Let's not peel off 3 pieces at once in the wrong direction. To paste without adding air bubbles as a whole To move past fingers to the left and right like the wipers of the car from the first part that you stuck, go obliquely towards the corner little by little, if bubbles get in, let it float a little It is good to paste it backwards.

It's a bit expensive, but there is nothing wrong with nothing

I feel a little expensive, but I used fire and I complained about the following points and purchased it. 1. Reduction of screen reflection 2. Reduction of finger slippage 3. Reduction of fingerprint adhesion 1. Screen reflection = 80% improvement. When it is bright, such as daytime, it reflects slightly even with this product, but it has improved to the extent that it is almost unnecessary. 2. Poor finger slide reduction = 100% improvement is smooth. I did not care about poor finger slip at all. 3. Fingerprint Adhesion Reduction = 80% Improvement If you keep on using it, it will not be conspicuous but you can confirm the adhesion of fingerprints slightly. However, the frequency of wiping off was drastically reduced and I am satisfied. In order to prevent the entry of dust, it is best to stretch in the bathroom after all naked. Regarding bubbles, it seems that there is a bubble-less process, and it disappeared as soon as it leaves for a while.

Satisfactory products

The recent anti glare film is good. When I purchased Antiglare film for the first time a few years ago, I abandoned the image quality too soon, and I have always loved glare since then. Because I watch prime video this time I emphasized easy-to-see and challenged anti-glare with my eyes lost at the end of my life. It certainly becomes like a film, but there is no sense of incongruity in Zensen compared with the old one. Rather, screen reflection and glare are relaxed and used comfortably. Of course, I think that there are places that can not be accepted depending on personal preference, but I think that you can be satisfied satisfactorily if you like glossy screens or those who require high definition and high image quality first. However, as you all say, you do not need two. Since it is good with 1 piece, I think it would have been better if you put in Glare and Antiglare one by one if you put in less than 1000 yen or 2 pieces.

It was a very easy-to-adhere film.

Since the seal of the adhesive surface of the film was divided into three parts, upper, middle and lower, it was possible to stick firmly to the screen and paste it. I usually do it over again in order to stick the seal straight, but with this product it was not there. I think that the sensitivity of the tap after pasting is also very good without any inconvenience. There are not any conspicuous scratches or fine scratches at the moment. The negative point is that the traces of peeling off the 3-part seal after the film is stuck on the side. Although it is not worrisome with the brightness of the screen during use, it is noticeably clear if the screen is dark. I thought it might be even 1 piece although it was 2 pieces.

It was a bargain for 2 pieces.

I bought it because it was affordable with 2 pieces. The size is perfect. I got a little bubbles, but it went well when I rub it for a while. Fingerprints are attached. There is no choice but to clean the beans. It is a necessity for liquid crystal protection.

Is good

Anti-reflection and fingerprint prevention are also effective. It tends to be cheap anti glare, I feel little color bleeding in the pasted state. The bubble escape is also perfect. I thought about putting it on 4980 yen kindle fire like cospa, but this one should be pasted.


SHIPPING METHOD

Delivered directly from Japan by Japan Post. It will take 3 to 5 business days to prepare the order for shipping. We guarantee careful packing and safe shipping.Please note that in some cases additional import or VAT charges may incur and have to be borne by the client.

1. Japanpost registered mail

Shipment by Japanpost Registered Mail (Standard). Trackable any time with tracking number. Insurance is not available. Delivery time usually is between 1-3 weeks from the date of dispatch. Some items are not eligible for Standard Shipping.

2. Qxpress Standard

Shipment by Qxpress standard service. Trackable at any time with tracking number. Registered and insured up to a value of item price and shipping fees.Delivery time is usually between 5-10 business days from the date of dispatch.

3. EMS

Shipment by Expedited Mail Service. Trackable at any time with tracking number. Registered and insured up to a value of $200 and usually delivered in 2-6 business day from the date of dispatch.

 Japanpost registered mailQexpressEMS
Shipping MethodJapanpost Registered Mail
(Standard)
Standard QexpressEMS
(Expedited Mail Service)
TrackableYesYesYes
InsuredN/AYes
(Up to item price and shipping fees)
Yes
(Up to $200.00)
Asia1-3 weeks5-10 days2-5 days
Oceania;
North America;
Central America
and the Middle East
2-4 weeks6-14 days2-6 days
Europe2-4 weeks6-16 days3-8 days
South America and Africa2-4 weeks10-18 days4-8 days

NOTICE:

  • For overseas delivery, please be aware that damage to the outer box can be seen.
  • If you would like to avoid as much damage as possible, please choose the EMS shipping method.

"According to Qoo10 guide line,overseas shipping fees will be charged to you extra if you choose Qxpress standard shipping.We recommend you to compare the total price of your purchase with EMS."