Color: BlackSize: 2.7 x 3.8 x 2.5cm (L x W x H)Screw length: 2cmAnti fog glass.CMOS imaging sensorSupport NTSC video system.Embedded mounting in rear bumper.Snap-in design， it is easy to install.High sensitivity and low power consumption.High-definition and 170 degree wide viewing angle.Water-proof， shock-proof and anti-jamming functions.Applicable to variety of vehicles: car， truck， RV， etc.It helps to avoid incidents and accidents abrasion well.Its simple and modest design and small size won't draw any attention.This camera can give you a full sight of the back of your car when you are driving.Low illumination level， it can work within 3 meters at night and other dark environments.To protect your car from collision with invisible obstacle， choose a high definition and good quality camera as ours.Perfect solution to get rid of that poor rear view visibility onyour car， boat， trailer， camper， truck or any vehicle that has no rear-view mirror or poor rear vision.Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted inside will fit into most vehicle key holes， no other installation needed.Specifications:Image Device:1/4 inch color CMOSTV system:PAL/.NTSCEffective pixels:628 x 582 PixelsSensing area:5.78 x 4.19mmSync. system internalResolution420TV linesElectronic Shutter1/50-1/10000 secondsMinimum illumination:0.3Lux/F1.2Lens angle:170°S/N ratiomore than 48db(AGC-OFF)ColorBlackVideo output:RCA CONNECTOR， 1.0VP-P， 75ohmCurrent Consumption:≤150mAPower supply:DC 12VOperating Temperature:-30°C to +50°C， RH95%Storage temperature:-40°C to +60°C， RH95% Max.Video cable length:6mPower supply cable length:1.2mInstallation:Take out your stock license plate light at the back of your car.b. Fix the camera to where the stock license plate light was.c. Connect the built-in license plate light of the camera to where the stock license plate light was connected to get the powerd. Connect the power of the camera to your Reverse lights - red wire to positive and black wire to negative.e. Connect the video cable of the camera to the extension cord.f. Connect the extension cord to your car monitor.g. You will see the images when your car is in reverse shift.IF it is possible we suggest that you should go to the 4S store for installing the kits.Package Content:1 x Car Rear View Camera1 x Video Cable1 x Power Cable