Usage:

A film tools: ruler ， scissors or a utility knife ， a wet towel ， hard card ( scraper ) .

2 with a ruler and a utility knife or scissors to paste the film planted into each position size ( best pen to write down on paper do not mistake size ) .

3 To film the place cleaned with a clean towel ， then wet the glass surface with a watering can ， you can put some detergent ( to be posted up after moving film ， not about sticky dead can not move ) .

4 . The matte film peeled off the backing paper ， stickers affixed in place to align the corners and smooth. Edge welt smooth with a wet towel to put down the glass and paste between the membrane ( inside ) air and moisture rub out ( if not all matte film is relatively large to remove the backing paper ， you can go to the bottom side welt paper ) .

5 After formation ， after the majority of the air and water together ， then scrape the blade on top ， the air bubbles ， scrape out the water the whole ， not too hard ， as long as the water can be scraped off completely and air can be.

6 After the dry water Please 12-24 hours ( time depends on the weather is sunny ，12 -24 out of the sun ) do not go cleaning ， moving . ~ ~ ~ ~ OK

Note : Some of my friends say do not be afraid to tear down the paste ， then ask you to place the sticker affixed to the glass with a ( 30-40 degrees ) or hot water heating with a hair dryer blowing hot in tear on OK， and fear have torn the glass there gum ( available hot water ， alcohol ， gasoline， kerosene ) the stuff a rub on clean ^ - ^ .

About Transport creases， bubbles : Because the baby is rolled sent ， there may be squeezed in the transport process ， visible air bubbles between the film and the backing