[Product Information]

100 Sheets (7.5" x 10.25" size) of pyrography carbon paper. Once you have selected the design that you will be carving and the wood surface has been prepared with any joinery work that might be needed for the finished project, the pattern is transferring onto the wood surface.
There are several basic ways to trace the design onto the wood. The most common way to transfer a pattern is by using carbon paper. This is a paper that is used with manual typewriters to create a secondary copy of the page being typed. The blue or black surface on the back of carbon paper rubs off onto any surface with which it comes into contact. Tracing paper is available at many drug stores, craft shops and office supply outfits.
Position the design on the wood surface and secure the paper with several strips of tape, either masking tape or clear tape. Slide the carbon paper with the black/blue surface facing the wood. Use an ink pen to trace over the lines of the pattern. As you trace the carbon paper is making an exact copy for you on the board. When you have copied every line of the design lift one or two pieces of the tape, leaving at least one piece still securing the pattern paper.
You can now check that you indeed traced the entire pattern. Carbon paper makes a clear dark line for woodworking pattern that easily carves away as you work without leaving any stain marks. Nor will it rub off the wood surface as you work the carving. However, it does not erase with a pencil eraser so any remaining lines in the carving will need to be shaved away with your knife.