Description:
1.Anti fog glass
2.CMOS imaging sensor
3.Support NTSC video system
4.Embedded mounting in rear bumper
5.Snap-in design， it is easy to install
6.High sensitivity and low power consumption
7.High-definition and 17 degree wide viewing angle
8.Water-proof， shock-proof and anti-jamming functions
9.Applicable to variety of vehicles: car， truck， RV， etc.
1.It helps to avoid incidents and accidents abrasion well
11.Extra-low illumination of .5 Lux for clear night vision
12.Its simple and modest design and small size won\'t draw any attention
13.This camera can give you a full sight of the back of your car when you are driving.
14.Low illumination level， it can work within 3 meters at night and other dark environments
15.To protect your car from collision with invisible obstacle， choose a high definition and good quality camera as ours
16.Perfect solution to get rid of that poor rear view visibility onyour car， boat， trailer， for camper， truck or any vehicle that has no rear-view mirror or poor rear vision
17.Connect to any type of monitor with a composite yellow RCA jack for crystal clear resolution mounted inside will fit into most vehicle key holes， no other installation needed

Specification:
Lens: 2.cm
Color: Black
TV System: NTSC
S/N Ratio: >48dB
Net Weight: 134g
Water-proof: IP66
Power: DC 12V±1%
White Balance: Auto
Sync. System: Internal
Video Cable Length: 6.m
Video Output: 1.Vpp， 75Ohm
Length Angle: 12~17 degree
Cable Length of Camera: 56cm
Scanning System: 2:1 Interlace
Power Supply Cable Length: 41cm
Image Reverse: Left-right mirror
High grade of waterproofing: IP66
Horizontal Resolution: 42 TV lines
Camera Size: 3.5(W) x 2.5(H) x 3.2(L)cm
Effective Pixels: NTSC: 51(H) * 492(V)
Current Consumption: No More Than 3mA
Image Sensor: CMOS 1/4 MT9V125 or PC13， color
Minimum Illumination: .2 Lux/ F1.8( Lux with LED)
Storage Temperature: -3℃ to + 6°C， 95% RH maximum
Operating Temperature: -2℃ to + 6°C， 95% RH maximum
Electronic Shutter: 1/5 to 1/1， seconds， 1/6 to 1/1， seconds

Installation:
1.Mount the camera inside the keyhole of your vehicle
2.Adjust the lens of the camera to its best position
3.Connect power cord to connect to your vehivle DC 12V power system
4.Connect the video output(yellow) of the camera to the display in your vehicle

Package Included:
1 x Video Cable
1 x Power Cable
1 x User manual
1 x Car Rear View Camera
2 x Screws(For Bracket Mount)