Popular PDR pulling bridge Works on virtually any flat, non-porous surface;Only a bridge puller not including the glue sticks
Have''Super PDR'' Logo on the products-our bridge puller has the ''super PDR'' logo on it, if there is not, it is a Fakes
Then,Place pulling bridge over dent pulling tab.;Meticulously inspected and certified for Rockwell Hardness
Twist turning knob until it pops the dent out!First,simply glue a dent pulling tab to the center of the dent
If you want to use our bridge puller to repair the dents,you must use the glue sticks with''Super PDR'' for make sure the repair effect.ASIN:B01D90SAAK
Popular PDR pulling bridge Works on virtually any flat, non-porous surface.
Have''Super PDR'' Logo on the products-our bridge puller has the ''super PDR'' logo on it, if there is not, it is a Fakes.
Meticulously inspected and certified for Rockwell Hardness.
How to operate:First,simply glue a dent pulling tab to the center of the dent,Then,Place pulling bridge over dent pulling tab,Twist turning knob until it pops the dent out!
Package:Only a bridge puller set.Note:If you want to use our bridge puller to repair the dents,you must use the glue sticks and glue gun to make sure the repair effect.the glue stick ASIN:B01D90SAAK

Technical Details

Product Details

Package Dimensions
Width : 5 inch
Height : 0.2 inch
Length : 5.9 inch

Shipping Weight: 10.4 ounce (View shipping rates and policies)

ASIN : B013D1FY0I

Product Description

How to use this paintless dent repair kits? 1.Clean the dent with a clean wet cloth;
2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.

Product list: 5pcs black glue sticks
5pcs yellow glue sticks