Studio : Ezyoutdoor

Publisher : Ezyoutdoor

Product Description
Tips:
When finish cleaning, dry the chain and then brush chain oil to avoid it rusts.

Instructions:
Cover the work space with newspapers or rags to catch excess cleaning fluid that drip from the chain during cleaning.
Remove excess mud,dirt and grime from the chain using the brush
Stabilize the bike in a repair stand and shift the chain into the middle or small chain ring up front,and the middle of the cog set in the rear.
Adjust the bike so that the lower portion of the chain is parallel with the ground.
Remove the locking handle by depressing the thumb lever and sliding the handle froward.
Then remove the lid by sliding it rearward and lifting.
Add enough LUFT degreaser or other cleaning fluid to reach the "FILL"line on the side of the reservoir. To avoid spills, do not over fill.
Position the Clean Machine on the lower portion of the chain, mid-way between the cog set and crank set,and replace the lid, making sure ti is completely flush with the reservoir body.
Slide the locking handle into place. You should hear an audible"CLICK"to indicate the handle is secure.
With a firm grip on the handle. rotate the crank slowly counterclockwise several complete rotations to clean the chain.
If necessary,refill the reservoir with fresh cleaning fluid and continue scrubbing until the chain is clean.
Dry the chain thoroughly with a rag to remove all cleaning fluid,and then lubricate the chain.
Wipe up spills immediately. Always dispose of cleaning fluid and soiled rags properly.
When finished,rinse the clean machine with water and allow to air dry.
Your Clean Machine will work best if used on a regular basis to prevent hard,caked on grime from accumulating on the chain
0