ESP8266 based soil moisture sensor Wi-Fi enabled.
<br />
<br />What is it?
<br />ESP8266 based soil moisture sensor Wi-Fi enabled. Also provide ambient temperature and humidity sensor.
<br />
<br />At the sensor's heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack. You can program the microcontroller using the Arduino IDE for an easy-to-run Internet of Things core. You can use ESP flasher R4 that an upload code at a blistering 115200 baud for fast development time. It also has auto-reset so no noodling with pins and reset button pressings.
<br />
<br />The sensor can upload sensor datas to remote server. We provided example code for uploading to thingspeak.
<br />The project is modifying of the I2C Moisture Sensor project from Miceuz. Thanks for his source code.
<br />
<br />What's difference with rev 1.0?
<br />
<br />Replace the DHT11 to TMP112 with I2C
<br />Add a jumper for wire GPIO16 and Reset pin
<br />Add a SWITCH for measuring soil sensor or battery voltage
<br />Pinouts compatible with ESPea
<br />Note
<br />
<br />Please choose "ESP8266 Flasher Rev2" add-on option if you want to programming the sensor.
<br />Please remove the jumper for GPIO16 if you want to program the board.
<br />Don't insert battery when you program the board.
<br />Hardware
<br />
<br />ESP-12F module x 1
<br />Button x 1
<br />Programming pinouts
<br />Red led x 1
<br />tmp112 temperature sensor (I2C) x 1
<br />Soil moisture sensor x 1
<br />AA Battery holder x 1
<br />Pinouts compatible with ESPea
<br />A jumper for wire GPIO16 to RESET
<br />Measures 35mm x 157mm
<br />AA battery not included. Please add AA battery x 2.