Studio : Robert Axle Project

Publisher : Robert Axle Project

Binding : Misc.

Product Description
Robert Axle Project thru axles allow modern frames to be used with axle mount trainers. Installed or removed using a 5mm Allen wrench. Measure trainer at the widest setting and measure the bike frame width at the rear hub. Application: Bike trainers. The Robert Axle ends will extend 15mm past the frame on each side. Designed, built and tested in the USA. For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more. IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using. Axle shaft and axle ends are machined from 7075 aluminum and hard anodized. Materials: 7075 Aluminum.
0