These 6 Ohm， 50 Watt resistors can be connected across the turn signal bulbs to simulate the load of a regular filament bulb. Solution for "bulb out signal" / "OBC error message" after installing SMD LED light bulb Solution for fast turn signal blinking response after installing SMD LED light bulb Installation is easy. Just connect the wires with the Splice taps provided and no wire cuting is necessary Universal fit， even though the parts compatibility list only shows 300 vehicles， but this product will fit any cars， SUVs or trucks. Simply tap the load resistors in between the turn signal light bulb's postive and negative wire and this will solve LED related turn signal problems such as hyper flashing， no flashing or burnt out bulb indications. Can be used with LED turn light of cars Beautiful golden aluminium housing Excellent heat dissipation With 4" wire at each end of the resistor and T-Taps for easy installation Power: 50W Resistance: 6 ohm Dimensions: Approx. 5 x 2.2 x 1.7 cm (1.97 x 0.9 x 0.6 inch)Package Included: 4 x Load Resistor 8 x T-Taps