Features

• When connected to a PC with a USB cable, DS-6000 DUAL of an external storage device function
• DS-6000 DUAL, 10 times faster than USB2.0, high speed 5Gbps speeds
• HDD with a protective cover for HDD to minimize vibration
• In particular, when you use 2.5" SATA HDD and SSD
• Electronics fully compatible with USB support
• HOT SWAP and the Plug & Play function
• Separate power switch Support for ease of use   

Specifications

• Support up to 1TB 2.5 inch hard disk
• 3.5 inch hard disk support up to 4TB (SATA / SATAII / SATAIII)
• USB 3.0 Super Speed (5Gbps Support)
• USB 2.0 High speed (480Mbps), USB 1.1 (12Mbps), USB1.0 (1.5Mbps) compatible
• Easy Plug & Play and Hot Swap equipped to support
• LED operating support
• One-Touch Backup (Clone) support
• Product Size: 110mm (L) x 130mm (W) x 86.7mm (H)

System Requirements

General PC

• Minimum PentiumII / 500MHz, 64MB RAM
• Windows 2000 / XP / VISTA / 7/8
• USB Port

MAC computer

• At least Apple G Processor, 64MB RAM
• Mac OS 9.1, 9.2, 10.1.5, 10.2, 10.3 or later
• USB port

Attention memo !

Target HDD capacity is the same or greater than the original HDD.
If the capacity of the Target HDD is small, HDD replication does not work.
But, when you clone the same capacity HDD, Target HDD must be greater or same than the original HDD 
as compared to the actual size, except the boot sector of the Target HDD.
(If They are the same capacity HDD, it is recommended to use the same HDD manufacturer and model name)

When CLONE is completed, HDD B slot does not visible in Explorer, because HDD of HDD B slot is set to 'offline'.
If, to use the HDD of HDD B slot, you must change the 'ON LINE' that HDD in Disk Manager.

Check a minute.
It is replicated all of the original source disk system, partition and data by CLONE function.
When the Clone function starts, Back up important data should be kept, beacuse the HDD data of HDD B slot will be deleted.

Target HDD (HDD B)
Please be sure to Back up.
The clone function does not work, if there are bad sectors.

LED DS-6000DUAL, you can see at a glance the clone process, indicate during clones in process 25%, 50%, 75%, 100%
on the front of the LED lamp.