Studio : Lyty

Publisher : Lyty

Product Description
Specification:
Needs 5/8 inch or 16mm diameter opening to install.
Fits dispenser wall up to 11/16 inch or 17mm thick.
Material:304 Stainless steel.
Thread Pitch: 1.25MM/0.05 inch.

Package includes:
1 x stainless steel spigot;
2 x stainless steel washer;
2 x silicon gasket;
1 x stainless steel nut;
1 x Anti-Clogging Cap;

Installation Steps:
1.Remove the Anti-Clogging Cap from the spigot;
2.Put a metal washer on the spigot;
3.Put a silicon gasket next to the metal washer;
4.Put the half assembled spigot through the hole of the dispenser;
5.Take another silicon gasket and put on the spigot from the inside of your jug/vessel;
6.Add another metal wash behind the gasket;
7.Put the nut and tighten it slowly;
8.Put the Anti-Clogging Cap on the end and tighten it. (Please avoid over tighten if your dispenser is glass)

Kindly Remind:
1. Make sure the Mounting Hole Size before purchasing.
2. Before installation, wash the stainless steel spigot in soapy water and rinse suggested .
3. Do not over-tighten, it could crack the dispenser made of fragile material like glass or ceramic.
4. If used for sugary drink, we suggest that remove the spigot from the dispenser and clean thoroughly.
0