Size 130-20cm

installation steps

Before the end of paper pasted <wet paste. Wash the adhesive area. Sprayed with a layer of water. Affixed after the end of paper. Blown away along the edge of the water droplets posted flat>

The flat edge cut <with a knife along the edge of the windshield to cut the excess paper at the end>

Location Logo <in the bottom surface of the paper good stick spray lightly covered the Monster Energy logo to find a good right here>

Location ghost <the ghost were affixed to both sides of the upper part of the lower half of stickers affixed to the roof at the end of the paper>

Cutting Blade <there is a gap between the roof and the glass portion of the slot will be in a ghost at the upper and lower portions are cut off， leaving only>