Studio : Migiwata

Publisher : Migiwata

Binding : Electronics

Product Description
Specifications:
Material: Aluminum Alloy Blade Holder and Carbide Blades
Length of Blades: 19 mm(0.78 inch)
Diameter of Blades: 0.9mm
Degree of Blade: 30 ° / 45 ° / 60 °
Compatible with: Graphtec CB09U CB09

Usage:
30° Blades (Blue cap) for Cutting large fonts and thick materials which about 1mm. (e.g.: reflective material, masking tapes, etc.)
45° Blades (Red cap) for Cutting general fonts and vinyl film. (e.g.: vinyl for traffic sign, flocks, etc.)
60° Blades (Yellow cap) for Cutting very small font intricate line-art logos. (e.g.: any thin vinyl)

Notice:
1. Blade should not extend too long, generally within half a millimeter is better, while paying attention to extended blade longer properly when carve the small print, in order to avoid the blade holder take the carved strokes away. Suitably engraved small print with new cutter and slow down.
2. When the word carved with angular phenomenon, you should change the blade to eliminate the problem, if the phenomenon persists after change blade, it should be the holder problem.
3. When problem arise the blade holder, try a drop of oil in the bearing and rotate the blade several times to lubricate, if still unresolved, consider replacing the blade holder.

What you'll get:
Blade Holder x 1pcs
45° Cutting Blades x 5pcs
60° Cutting Blade x 5pcs
30° Cutting Blade x 5pcs
Springs x 15pcs

The blade holder is also sold separately.
Blade Holder and Blades set: http://www.amazon.com/dp/B077JFG2K5
Blade Holder: http://www.amazon.com/dp/B077JMNVK2
0