Suitable models]: lever screw-thread diameter 10-12MM of manual models can be installed !!

【installation method】:

1. Remove the original car stalls head first (original car stalls head because different models required different methods to remove)， this product is not available for Buick， Chevrolet certain models such as the original car with a reverse gear shift lever ring models ;

2. Unscrew the bottom of the gear shift knob black decorative cover， together with the former set into the car shift lever， gear shift knob with this subsection comes three locking nut gear shift knob;

。

3. Check to see that place， with or without shaking， shaking head gear as a result of the case after the original car size smaller shift lever caused by installation， some duct tape wrapped around the original car stand rod and then tighten the lock nut， good results.