MKS Gen V1.1 3D Printer Control Motherboard Compatible RepRap Ramps1.4 With USB Cable
Feature:
It gather 2560 and ramps1.4 on a same board， which solved the Ramps1.4 combination interface problem， which easily out of orderCan replace the motor driver， support 4988 drivers and 8825 driversCircuit board uses the high quality of 4 layer board，optimize heat dissipation;Ramp Is 2 layer boardUsing special power supply chip， support the 12v-24v power input， solve the problem of Ramps voltage conversion of chip feverCan accept 24 v input， under the same system power can reduce the current hot bed to 1\/4， effectively solve the problem of hot bed MOS tube heatingThe firmware can use open source firmware Marlin， configuration are exactly the same with ramps1.4 ， can be directly replace ramps1.4 alsoCan be connected directly to Ramps1.4， 2004 LCD control board and the LCD board (12864)Provide three 5V output， three 12V-24V output interface
Notice:
If the power supply is wrong connection， motor driver board is likely to be burned chip and circuit， please confirm again after repeatedly for electricity
Package included:
1 x MGK Gen V1.1 Motherboard1 x USB cable