[Adjustment of mesh] <br> 1. Set the powder catcher, turn the adjustment nut to the right until it stops <br> 2. Open the lid and place the coffee beans in the hopper Place on a solid table such as a table, hold the main body, close the lid, turn the adjustment nut slightly to the left, turn the handle to the right and actually grind the beans Adjust until it becomes your favorite mesh while adjusting ※ You can confirm the adjustment with a little beans. Rotating the adjusting nut to the left causes the mesh to become coarse. You can not grind beans properly even if you turn the steering wheel to the left <br> 4. When the noise to be ground of coffee beans stops, the finished coffee powder. Remove powder receptacle to use 【Caring】 <br> · When the main body and powder receiver become dirty, always wipe clean with dry cloth · inside the hopper, remove the coffee powder accumulated in the groove of the powder receiving with a brush etc.