ST Pro Puller was designed to remove the golf club head
Rubber coated pads ensure shafts are not damaged
Max Height 10'' (T-handle fully opened) x Max Length 8''
A must have tool for any serious golf shop
Proudly Made in USA (Toledo Ohio)

Technical Details

Product Details

Package Dimensions
Width : 10.1 inch
Height : 4.7 inch
Length : 10.1 inch

Shipping Weight: 4.5 pounds (View shipping rates and policies)

ASIN : B00DN7B3W6

Product Description

LogCorp Pro Puller Golf Club Shaft Extractor made from Anodized Aluminum
ST Pro Puller was designed to remove the golf club head. Loading clubs and unloading has been made quick and easy. Rubber coated pads ensure shafts are not damaged. Pressure is applied using the threaded rod & T Handle. Vise mounted for stability.
Operation of use:Turn side screw untill full extracted, while turning the T-handle until fully openCut the ferrule off club shaft and install rubber clamp protector around the shaftPlace the club into the vise and place the hosel protector between the hosel and the push flange and adjust rubber protector as needed to ensure it lines up in the middle of the viseTighten T-handle to clamp the shaftUsing a wrench turn the side screw until the push flange is tight against the hosel.Heat the hosel. Move the heat up and down and around the hosel for even heatingOnce the Exopy starts to get hot, start with a little pressure on the wrench turning the side screwWhen the head starts to move off, stop the heat and continue turning the nut until the head is offMax Height 10'' (T-handle fully opened) x Max Length 8''Mounts in any Vise or BenchtopA must have tool for any serious golf shopProudly Made in USA (Toledo Ohio)Bench vise NOT included