Without destroying the original car power supply， no wiring， installation without removing the wheels， without invite people to install，
Installation process takes only ten minutes own hands save time and money! !
Somewhat less ability friend， you can find a repair shop to install decorative beauty shop!
The first time， let the sun exposure 8 hours after use.
Features:
1. Solar automatic charging， the product uses high efficiency solar cells.
2. Built-in lithium battery， the product uses high-capacity lithium battery， A product batteries， no memory effect and longer life.
3. High brightness， ultra bright imported chips LED， night driving have shown wide warning， decorative effect.
4. Intelligent opening function， the product uses light control and micro-vibration sensor system automatically turns on when driving at night flashing.
5. Intelligent off function， the product uses single-chip， there is a delay in the closed system， in which the vehicle is stationary state park or turn off automatically after 30 seconds.
 
Installation is simple， colorful lights， see the video above
     Solar lights upgraded version of the hub / wheel arc lamp / Hot Wheels / tires Lights
      Installation is simple and durable super super super gorgeous waterproof
       Color can be free to switch monochrome color
       Dim light can be turned to open will send shock plus gorgeous lighting
      (After the switch is turned on， the light will shine dark plus vibration)
     
  The product color， colored light， the following is a product issue more
Light colors real shot pictures Oh!
Research and development of this product is defined as meaning: warning lights traffic safety instructions. Such as night， rain， snow foggy day can play a prompt warning， make cars safer in bad weather affect. And the results are unique fashion personality， in fact， essential supplies automotive! Proposed purchase

Instructions for use:

In low light conditions， press the switch button 3 seconds after opening， long closed again by three seconds.

Mode selection， press and hold 3 seconds after entering the automatic mode is turned on， the color changes automatically， in the open state press the switch to red lights work， according to two under the switch to green light work， according to three times the switch turned blue lights work， press the switch again to turn the automatic mode.

Note:

1. Before use please charge in the sun for more than 3 hours;

2. External frequent cleaning products， keep the surface clean to ensure that the product is working properly;

3. Tighten each screw securely install the product， in order to avoid the product in the high-speed rotation of the wheel will not come off.

Installation instructions:

1. Use a small flathead screwdriver to remove the original wheels car standard;

2. Measure the diameter of the original car the subject of catches or common values with a caliper measurement tools

3. Use a screwdriver to this product card foot diameter screws loosen;

4. Follow the card feet in diameter previously measured values needed to adjust the diameter of the good， the four pins need to be adjusted to keep the product of four pins centrosymmetric， adjust and tighten the screws after the completion;

5. Measure the height of the original car the subject of catches or common values with caliper measurement tools;

6. In accordance with the original measured value card installed foot height positioning buckle， four highly consistent positioning buckle;

7. Place the retainer clips on the inside of the card in the middle position of the four feet of the pin， pin to ensure its elasticity;

8. The product is pressed into the hub of the original car standard position;

9. The light cover， press the switch 3 seconds to open the product， the entire installation is complete.