[product name]: multi-functional protective film

[performance]:

1， Mount completely isolated from the outside world， anti dust， anti polish，clean and other functions in the car.

2， the protective film surface with a wear layer to prevent scratchesscratches， can reduce the formation of.

3， not because of the high temperature caused deterioration，discoloration， in complex surface does not change the properties of the product.

4， excellent ductility for arbitrary angle mount， greatly reducing theconstruction time.

Acrylic pressure sensitive adhesive 5， high performance， long protect the surface， keeping time of up to three years.

6， reduce the chamber cleaning costs， save money.

[specification]:

Commodity width: 10CM

Film thickness: 0.10mm.

Extensibility: 1:2

Viscosity: Super

Super paste:: lasting

Molding: complex surface

The residual gum: no

Rally: 20Pa

Impact: 2.5kg

Anti heat: 60 degrees Celsius corrosion

[function]:

You have to get on and off the dirty car door， car interiors and trouble?Put this product you will not for this sad， dirty gently wipe clean.

Instructions for use:

Please use according to the instructions on the packet， please make sure that the sticky bit thoroughly clean before pasting viscosity， pleaseaccording to a period of time to ensure the firm， 12 hours do not wash the car.

In order to make the paste position more accurately， suggested before the paste products will be soaked in water or alcohol for a period of time and then paste， a layer of water film products and paint， is convenient to moveto the exact position and completely get rid of the bubble.

Drive in outer， one not careful， a car door handle is female passengersnails scratching， one not careful， the edge of the door of the car andpassengers were shoes get dirty. Although this is not painful accidentdoes not itch， but as a car such as the life of the owners， how can you notworry? Don't worry， if you have trouble in this area， today we introduce to you a good way!

[method] prefix = O installation ns = "urn:schemas-microsoft-com:office:office"

A， use alcohol or foam cleanser will all want local dirt clean， such as the surface wax must open wax water and 60 degrees above water wash(important).

Two， the film and the door trim shape to make a comparison， cut the excess part.

Three， the mucosal tear stuck in it， such as uneven places a hand pulledto one side， and then the hot air gun (or hair dryer) heating， gently press.

Four， please go to the car decoration professional facilities construction.

The door film process map:

1 first than to stick parts need how much protection film

 

Prefix = V ns = "urn:schemas-microsoft-com:vml"

2 the need to paste the area clean， make sure no impurities or what the wax

 

3 the surface wet with alcohol

4 torn off at the end of paper， the film is pasted

 
The 5 scraper to sprinkle fine scraping， can not use the bank card ormembership card替 

Part 6 trim corner excess

 

7 roast gun corner and drying， at the same time with the scraper scrapingwill be accomplished (grilled gun can be replaced with a hair dryer)

Can also be used for door bowl， the rear guard board， door trim panels，mirror...... 

Practice: DIY to the car door handles sticking "rhinoceros skin" process

1 door handle paint will finish on the dust and impurities in clean

 

2 of the original door handle of cleaning is best used with no impuritiesbarreled pure water to wash，

In addition to water wet， can in the paste operation mistakes corrected in a timely manner.