TYENT Rettin Compatible Replacement
Ionizer Filter Set 1st + 2nd + Cleaning
for MMP Series
Time for a filter change! Are you searching for the Tyent replacement filter kit for your Tyent water ionizer? If so, you found it, and at the best price available online.
These are high-performance filters that truly achieve the purest water you'll ever drink in your life.
Product Features:
This replacement filter kit was designed by Tyent USA to work for the MMP 5050, MMP 7070, MMP-7070 Turbo, MMP-9090 Turbo Extreme, MMP-11 Plate and Rettin TY 2505W!
These filters are designed to last somewhere between 9-12 months, depending on the frequency at which your machine is used. If you are using it in excess of 20L per day, your filter life may be shortened to somewhere around 6 months (3600L).
*Compatible Replacement Filter Set for Tyent MMP Series MMP-2505W, MMP-5050,
MMP-7070,MMP-7070 Turbo, MMP-9090, MMP-9090 Turbo, MMP-11 Plate
*This filter doesn't fit to the UNDER-COUNTER UCE9000/UCE11
*These filters are Tyent compatible STANDARD (1 Micron) replacement filter manufactured
by Korean OEM manufacturer.
*Certified by NSF for drinking water treatment units
The filter uses the Activated Carbon from KURARAY CHEMICAL(JAPAN)
The Activated Carbon is certified by NSF Certification of NSF International Certification of Korea,
Environment & Water Works Institute, Certification of Korea Testing & Research Institute
*MADE IN KOREA/These filters are Tyent compatible replacements made by Korean OEM manufacturer.
Directions For Use of Cleaning filter:
1) Turn off your ionizer and shut off the water supply going to the unit.
2) Locate the filter housing of your ionizer and remove the 2nd Filter.
3) Attach the Citric Acid Ionizer Cleaning Cartridge. Do NOT over tighten!
4) Turn on both the power to the ionizer as well as the water supply.
5) Run water through the ionizer using the H2O CLEAN mode. DO NOT use any other mode when going through this cleaning process!
6) Allow H2O Clean water to cycle for 5 minutes.
7) Do not operate the machine for 3 hours.
8) After 3 hours, follow steps 1-4, replacing the Citric Acid Ionizer Cleaning Cartridge with the original filter.
9) Run the unit on the H2O cycle for 5 minutes to wash the filter inside with clean water.
10) Check pH levels of the machine and flow rate. The pH levels should return to normal. If not, repeat steps 1 through 9. The process can be repeated up to FOUR times with one cartridge.
NOTE: When cleaning your Tyent machine, be sure to always use the H2O purified water level only! Do not use any other level while cleaning or damage could occur.
NOTE: If your water ionizer is subject to hard water conditions, a Cell Safe Anti-Scale filter should be connected. This filter will prevent scale build up on plates.
Product Description
*Quantity: 1ea 1st filter + 1ea 2nd + 1ea Cleaning Replacement Filter
•SIZE: 68.5mm X 300mm
•WEIGHT : 400g
•Filtration Capacity: 3600 liter