Features:<br /><br />Supported MegaPirateNG/ ArduCopterNG/ArduPlaneNG/MultiWii/AeroQuadand firmware;<br />Up to 8-axis motor output;<br />8 input channels for standard receiver and PPM SUM;<br />4 serial ports for debug/Bluetooth Module/OSD/GPS/telemetry;<br />2 servos output for PITCH and ROLL gimbal system;<br />A servos output to trigger a camera button;<br />6 Analog output for extend device;<br />A I2C port for extend sensor or device;<br />Separate 3.3V and 5V LDO voltage regulator;<br />Built-in 16Mbit data flash memory chip to record the data automatically;<br />ATMega 2560-16AU Microcontroller;<br />MPU6050 6 axis gyro/accel with Motion Processing Unit;<br />HMC5883L 3-axis digital magnetometer;<br />MS5611-01BA01 highprecision altimeter;<br />FT232RQ USB-UART chip and Micro USB receptacle;<br />On board logic level converter.<br />Input power selection:<br />One of the following ways;<br />Connect 5V power cable from ESC or UBEC to the ESC/Servo port， the J1 jumper must be closed.<br />Connect 5V~12V power cable to the extend power port， the J1 jumper must be removed.<br />When using Extend Board， AIO PRO must be powered from the extend power port <br /><br />Packing List:<br /><br />1 x Flight controller<br />1 x 3Pin to 3-Pin cable (10cm)<br />3 x 3Pin to 1-Pinx3 cables (10cm)<br />1 x 1.25mm 4-Pin cable (14cm)<br />1 x 1.25mm 6-Pin cable (14cm)<br />1 x 1.25mm 8-Pin cable (14cm)<br /><img src="http://img6.eachbuyer.com/x9/p100/eb00196_1.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb00196_2.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb00196_3.jpg" />                                                        <img src="http://img6.eachbuyer.com/x9/p100/eb00196_4.jpg" />