Package included:<br />1 x 12V 1 Channel Wireless Relay Switch<br /><br />Specification:<br />1.Input Voltage: DC10-14V<br />2.Standby Current: ＜5MA<br />3.RF Frequency: 433MHZ <br />4.RF Working mode:Super heterodyne receiver<br />5.Receiver Sensitivity: >90dBm<br />6.Remote Control Distance: >100 meter(In open environment)<br />7.Decoding Way: MCU Software decoding<br />8.Can store the number of remote control:20<br />9.Support remote control type: Fixed code， learning code<br />10.Channel: 1CH<br />11.Multiple working modes: (Jog/Non-Latched ，inter-lock/Latched ，self-lock /Self-Latched)<br />12.Wiring Method:Fixed wiring terminal<br />13.Working Voltage: DC12V<br />14.Output Current: 10A<br />15.Rated load:10A 250VAC / 10A 125VAC<br />                 10A 30VDC / 10A 28VDC<br />16.Output:Normally open，Common，Normally closed<br />17.Dimension:3.5cm*3cm*1.6cm<br /> <br />Working/output way:<br />1.Jog/Non-Latched: Press one button is Working /ON.  Loosen your finger on the same button is Stop/OFF.  One channel switch need one buttons remote control.<br />2.Self -lock/Self-Latched: Press one button for one time is working/ON.  Press the same button again is stop/OFF.  One channel switch need one buttons remote control.<br />3.Inter-lock /Latched: Press one button is working/ON， press another button is stop/OFF.  One channel switch need 2 buttons remote control.<br /><br />Learning :<br />1. Jog mode: press the learning key once， the LED indicator light flashes once， etc. When the LED indicator light is on， press the remote control button that needs to code， the control panel LED indicator flashes 3 times successively.<br />2. Self-lock mode: press the learning button 2 times， LED indicator light flashing with 2 times， and so on LED lights lit and press the need for the code of the remote control button， the control panel LED indicator flashes 3 times success.<br />3. Interlock mode: press the learning key three times， LED indicator light flashes three times， and other LED lights and press the need for the code of the remote control button， the control panel LED indicator flashes 3 times a success code.<br />Note:If want to change the modes， need delete the present learning mode(Press the white learning button on the control panel eight times)， and then re-learn the new features<br /><br />Remove/clean :press the learning button about 8 seconds ， the indicator turn on to off， it means the information that you keep have been removed successfully . <br /><br />Note: It can learn 2272 2262 or 1527 chip with the different code wireless 433MHz remote control <br />