Description:
DSO 068 DIY kit uses through-hole components as much as it can. This makes the scope unique among peers. With through-hole components the kit eases off the requirement of assembly skills and at the same time allows deeper user involvement. Most importantly it brings in the freedom for users to test， modify， experiment， and even design their own projects. And this means more fun. Moreover， DSO 068 is not just a kit for training but also a practical tool for everyday use. It was designed on the base of DSO 062 kit and comprises many enhancements in hardware and firmware.

Main Features:
● Vertical position adjustable with indicator
● With DC / AC coupling
● With Auto / Normal / Single trig modes
● Observed waveform before trigger (negative delay)
● Can freeze at any time waveform display (HOLD function)
● With 1Hz - 4MHz variable frequency test signal source
● Waveforms can be saved to EEPROM when shutdown will not lost
● You can easily take out the display saved waveform
● It can change the display screen to a graphical file format sent to the PC via the serial port
● Frequency meter can measure frequencies up to 5MHz， the sensitivity up to 0.2Vpp
● There are 256， 512 and 1024-point FFT function， support the signal spectrum analysis
● Higher sensitivity (10mV / div vs 100mV / div)
● Wider analog bandwidth (3MHz vs 1MHz)
● Larger capture buffer (1024 points vs 256 points)
● Variable trigger position (1 percent - 100 percent) with indicator
● Test signal generator with variable frequency and amplitude
USB connection
● Upload captured raw data as CSV file
● Work as USB scope and data logger (8 channels， 10-bit resolution)
● Higher sensitivity (0.2Vpp vs 3Vpp) in built-in frequecy meter