Quick view
*The same ingredients dentists use
*Relieves pain instantly
*No mixing, fast drying
Designed to repair with the same ingredients dentists use.This is only a temporary remedy meant to replace a lost filling, cap, crown or inlay until you have a chance to visit your dentist and should only be removed by a dental professional.Visit dentist within 48 hours of use.
*Dentist strength
*Relieves pain instantly
*No mixing
*Fast drying
*Safe to eat on
*Applicator easily reaches back teeth
*8+ repairs
Made in Italy
100% Satisfaction guaranteed with all Walgreens products or your money back. 100% satisfaction guaranteed
To replace a lost filling:Wash the cavity area with warm water and do not dry.Cut or pinch a small amount of product from the vial and roll into a ball between fingers.Slightly overfill the cavity and tamp into place with a cotton swab moistened in water.Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filing a couple times to create a comfortable bite.Use a moist cotton swab to remove excess from the area.Moisture will accelerate the set.Product will set softly in your mouth within minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.
To secure loose crowns, caps, or inlays:Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface.If you are not able to do so, then do not proceed further.If the crown has a post attached to it or if there is tooth surface remaining inside the crown, product may not adhere.Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry.Cut or pinch a small amount from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay.Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position.Product will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set.Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.© 2012 Walgreen Co.