Using both faradic and iontophoresis therapy? Lift allows you to feel the effects after just one use and see visible results in just a few days

Features:

Practised for over 40 years in beauty salons? faradic facial toning uses EMS (Electrical Muscle Stimulation) to gently contract and relax facial muscles to help tone? lift and tighten. This stimulation also increases local circulation? bringing more oxygen to the skin cells and removing toxins more rapidly? to leave the skin feeling refreshed and rejuvenated.

Iontophoresis Infusion uses small micro currents to carry the active ingredients for skin repair and rejuvenation deep into the skin. This transdermal infusion greatly increase the effectiveness of topically applied treatments which would otherwise find it difficult to penetrate skin. Lift gel patches contain positively charged collagen and retinol as anti-wrinkle and anti-ageing agents. When placing the positive contact on the patch and the negative contact on the skin? these active ingredients are directly 叢ulled・into the skin.

How to Use - Faradic Facial Toning:

Faradic Facial Toning Treatment Zones

Step 1: Apply a generous amount of conductive gel to each of the ball contacts? turn the unit on then position both ball contacts on the area to be treated. Hold the unit in position for 60 seconds to complete treatment of the area. After 60 seconds move onto the next treatment area.

Step 2: During treatment you can increase the power and move the position of the ball contacts if necessary until you feel definite muscles contractions. You may need to adjust the intensity level when treating different areas of the face.

Faradic Facial Toning Programmes

Programme 1: FirmingRhythmic muscle contractions to condition muscles with a short interval between each pulse. Muscle contractions last 2 seconds followed by a 3 second pause. There are 17 power levels in total. We recommend starting on a low power level on each treatment area and build up until muscle contractions are felt.

Programme 2: Tap ToningRapid stimulating action. The pulsing massage action lasts 5 seconds followed by a 3 second pause.

For best results follow the faradic facial toning regime every day for the first few weeks? alternating between programmes 1 and 2 each day.

How to Use - Iontophoresis Infusion:

Step 1: Apply a generous amount of conductive gel to each of the ball contacts? turn the unit on then position both ball contacts on the area to be treated. Hold the unit in position for 60 seconds to complete treatment of the area. After 60 seconds move onto the next treatment area.

Step 2: During treatment you can increase the power and move the position of the ball contacts if necessary until you feel definite muscles contractions. You may need to adjust the intensity level when treating different areas of the face.

Faradic Facial Toning Programmes

Programme 1: FirmingRhythmic muscle contractions to condition muscles with a short interval between each pulse. Muscle contractions last 2 seconds followed by a 3 second pause. There are 17 power levels in total. We recommend starting on a low power level on each treatment area and build up until muscle contractions are felt.

Programme 2: Tap ToningRapid stimulating action. The pulsing massage action lasts 5 seconds followed by a 3 second pause.

For best results follow the faradic facial toning regime every day for the first few weeks? alternating between programmes 1 and 2 each day.

How to Use - Iontophoresis Infusion:

Step 1: Thoroughly clean and dry skin. Do not apply moisturisers. Tear along the perforated edge of the Collagen and Retinol patch sachet. Take a patch from the plastic casing and peel off the liners to reveal the gel patch.

Step 2: Place one patch onto the area to be treated. Place the other patch on the opposite side of the face.

Step 3: Apply a generous amount of conductive gel to the (-) ball contact. Always apply plenty of conductive gel to ensure good contact with the skin.

Step 4: Select programme 3? Infusion? by pressing the programme/on/off button 3 times. The green light will flash three times to indicate programme 3 is selected.

Step 5: With the (-) ball contact touching the skin and the (+) ball remaining on the patch? slowly and gently move back and forth along the patch for 60 seconds.Increase the power until a steady tingling is felt.

Step 6: Repeat the process across the other patch. Continue treatment by alternating between patches for 10・0 minutes (5・5 minutes on each patch).

Step 7: The patches may remain on the face for up to 1 hour to continue gently infusing. After removing patches? you can massage any residue into your skin.

Step 8: After use? switch the unit off. Press and hold the programme/on/off button for 2 seconds. Note: If unit is left on? it will automatically switch off after 10 minutes.

Iontophoresis Infusion Programme

Programme 3: InfusionThe infusion programme gives a continuous high frequency sensation. There are 10 power levels. We recommend starting on a low power level on each treatment area and building up until a strong tingling is felt.Important: For infusion you must remember which ball contact is which polarity. The (+) ball contact? should remain on the patch while the (-) ball contact remains on the skin.

Precautions:

Contents: