X-CAM A10-3H V 2.0 Version 3 Axis Brushless Gimbal for GOPR3 GOPR4 Rotating 360 Degrees
Details:
Discriptions:User Manual
Weight: 280g ( without GOPRO )
Stabilization frequency: 5200Hz
Input voltage: 7.4v ~ 16.8v ( 2S ~ 4S Lipo )
Tilt travel: +-90 degree; Roll travel: +-45 degree
YAW travel: 360 degrees unlimited rotation
Built in AVouput&Charging Module
Auto Pilot System supporting is not required
Built in 3 Gyroscope sensors & 1 Position sensor
Supports automatic location function
AV ouput & Charging Module has been insided
Does not need any Auto Pilot System supporting
3 Gyro sensors & 1 Position sensor inside
Supports automatic location function
The S-BUS output provides full functions, all function has been defined channel number:
Channel 1 : ROLL Control
Channel 2: Return to HOME
Channel 3: TILT Control
Channel 4: YAW Control
Channel 5: Mode Switch
The recommend operation ways:
1. Single person: Just connect PPM channel for switch HEAD FOLLOWING , HEAD LOCK and AUTO BACK TO HOME, does not need to connect S-BUS channel, One receiver can be used.
2. Two persons: Does not need to connect PPM channel, only S-BUS output channel provides full functions. But needs 2 receivers
Attention:It does not required to supply the power to the receiver when under dual control mode,the A10-3H controller will supply the
power to the receiver via the S-BUS.
Notice:
Do not touch the gimbal during the initialization after turn on, Keep the gimbal in quietude.
Do not use BEC for the gimbal power, pls use 2~4S Lipo battery.
Strongly suggest using 12mm tube to mount the gimbal.
Make sure the center of gravity of the gimbal is correct before using.
Package Included:
1 x X-CAM A10-3H Gimbal Frame
1 x X-CAM A10-3H Controller
1 x USB Cable
1 x PPM Cable
5 x Damping balls
4 x Rubber rings
4 x Fastener rings