Descriptions:<br /><br />Type: Skin Sticker<br />Media: Video Game<br />Install<br />1) Clean your controller surface as thoroughly as possible. Use rubbing <br />alcohol on a lint-free<br /> cloth to remove any grease or other contaminates. Most issues of non-sticking <br />are due to<br /> some type of oil or grease that is on the unit prior to installation.<br />2) Peel one piece of the Skin from the paper liner. NOT to let the adhesive <br />side touch anything.<br />3) Determine the placement・ apply the Skin to the surface using your fingers <br />or the side of your<br /> thumb・ starting from one corner and working your way across the surface.<br />4) If a decal sticker piece is not going on straight・ you can gently lift the <br />sticker back up. Do not stretch it from its original size.<br />5) If installed slowly and carefully・ there should be NO air bubbles left <br />under the sticker skin.<br /> Any air that may become trapped under the sticker skin during installation <br />will go away in time. You can also use a pin to break it.<br />6) During the cold weather or for a better result・ apply hot air to the decal <br />surface to activate chemical agent after putting the sticker<br /> skin on your Controller. Especially heat up the edge surface. Allow at least <br />3 hours for cool down before touching the decal sticker skin.<br /> Using a hair dryer or hot air gun is fine.<br /><br />Package includes:<br />1 x Skin Sticker<br /><br />Cool products.