BDM100 ECU reader programmer/remapping chip tuning tool
Solves problems resulting from lack of connection from the OBD connector to the ECU or for very new ECU versions
Adopts an MPC5xx processor which contains 448KB-1MB flash memory
The memory cannot be read or programmed with an eprom programmer
BDM-100 requires the ECU to be opened and removed so that you can connect a flat cable to the specific area of the ECU
Connect the other end of the BDM100 to the USB port of any computer
Allows users to read and program the complete ECU including 29BL802 SSOP eprom file (or ROM memory with maps if eprom physically not present)， Motorola MPC5XX processor file and Serial Eprom content
Connects these solder pads of the BDM port with the WinOLS PC over the USB bus
Obtain its operating voltage from the USB bus
Voltage: 12V
Please note that even in the case of ECU blocking due to the wrong checksum recalculation， the ECU can always be reprogrammed and retrieved (if the original software has been previously stored).

Package Details

Weight: 448.33 g
Size: 15.5*12.8*5.7 cm

Package Includes

* BDM Interface
* ECU Connecting Cable (connect to ECU)
* 3 x Adapters (Siemens， Delphi， Merelli)
* USB Cable (connect to PC)
* 12V Power Supply
* CD with Software and Drivers