500A car battery emergency clip line

Products: car 500A battery line /2 meters battery connecting line of 12V emergency takefire ignition wire / Jiang Long

Specifications: length: 2 meters, net weight: 0.6KG

When your car because don't worry no power could not beat the car from the side of the road, hit a taxi at a clip easily. Very few cars had no electricity, but once in a while have no electricity, really annoying. Not afraid of ten thousand, just in case, or take a battery clipwill be good. Without any menace from the "rear".

The procedure is as follows:

(1) the start line of the red wire clamp on "red cell anode was saved.".

(2) and then the other side of the red wire clamp red cell anode in the "rescue" car.

(3) the black wire clamp on the "black car battery is saved".

(4) and then the black wire clamp in the "rescue vehicle" black negative battery.

(5) to start the engine of the "rescue vehicle", and then start the "rescued" car engine. If it is found that the rescued the car still can not start, check the metal contact parts is bad.

When completed to start the engine, still need to be removed in order to start a fire, or they may cause a short circuit.

Remove line procedure is as follows:

(1) the "rescued car" black wire removed.

(2) the "black wire rescue vehicle" removing.

(3) and "the red wire rescue vehicle" removing.

(4) the "red wire rescued car" removing.