DIY Kit Mini USB Boost Single Turn Dual Power Module<br /><br />Main Features:<br />? According to the output power requirements， select a sufficient output current of the input power， or it may not start. <br />? The machine total output power should not exceed 10W， can provide short-term high current single output， but this time be sure to pay attention to the heat sink temperature， not too high so as not to damage the IC. <br />? If you do not have experience， please control the output current of each channel to less than 0.2A is appropriate. Excessively large output current may cause damage to the IC overheat.<br />? Each output of the IC have protection， but when used to avoid a short circuit， all output wiring connections should be completed and then turn on the power.<br /><br /><br /><br />    Specifications<br />General<br />  Suitable for: Arduino                                                  <br />                        Output Voltage: +12V， -12V， +5V， -5V， +3.3V                                                  <br />                        Output Current: 300mA                                                  <br />                        Max. Input Voltage: 5V-24V                                                 <br />Connectivity <br />  Ports: Mini USB                                                 <br />Weight and Size<br />  Product weight: 0.025 kg                                                  <br />                        Package weight: 0.050 kg                                                  <br />                        Product Size(L x W x H): 13.000 x 9.000 x 3.000 cm / 5.118 x 3.543 x 1.181 inches                                                  <br />                        Package Size(L x W x H): 16.000 x 11.000 x 5.000 cm / 6.299 x 4.331 x 1.969 inches                                                 <br /><br /><br /><br />                                            <br /><br />Package<br />Contents<br />  2 x 35V Electrolytic Capacitor<br /> 8 x Ceramic Capacitor<br /> <br />7 x 16V Electrolytic Capacitor<br />  2 x Diode  <br /> <br /> 5 x Line Resistance<br /> 6 x Chip<br /> <br />3 x LED<br /> 3 x Chip Inductor<br /> <br /> 6 x Heat Sink<br />  1 x DC Power Head<br /> <br /> 1 x Mini USB<br />  1 x Pin<br /> <br /> 1 x 2 Bit Power Supply Terminal<br />  2 x 3 Bit Power Supply Terminal<br /> <br /> 1 x PCB Board<br />  1 x Clapboard<br /> <br /><br /><br /><br /><br /><br /><br /><br /><br /><br /><br /><br /><br />                                                <br />