30 LEDs

Power: 48W
Machine piput: DC12/3.0A (this product with battery power  function)
Adapter: Rated input: 100-240vac 50/60Hz 1A
              Rated output: DC 12V/3.0A
Parameters of battery pack: power:3350mAh
         Charging voltage: 5v/12.6v Charging current:1-1.5A
         Discharge voltage: 9-12.6v Discharge current: 0-3A
Size: 212x211x97mm
Wave length: 365+405nm
 
 
How to use:
 
1.Connect to the adaptor, and then plug in.
2.You may set the curing time by pressing the related times(10s,30s,60s,99s)
3.Press the timer button during the cure,the timer will be reset.
4.Put your fingers under the lamp, and it triggers the infrared sensor to start the curing process. the default process lasts for 120s.
5.Press the related button(10s,30s,60s)for about 2s,this initiates the curing windows accordingly.press again for 2s or press another timer to cancelit. press the 99s button for 2s to power on/off
6.Press the 99s button together with the 60s button for about 2s when adaptor is utilized,and it doubles the power. press again for 2s to cancel it(double-power works only if 10s,30s,60s or infrared timer are applied)press the 99s button for 0.5s to initiate the low heat mode, it enables the power output ti increase.
7.Press 10s,30s or 60s button, the timer goes countdown,press 99s button or when infraed sensor is triggered,the timer goes count up.
 

 

Charging methods:

 

         Full charge, can be continuous long 2 hours, the normal nail shop available 1-2 days (small capacity, no security risks)

 

warm tips:

 

     1 When not in use, please turn off the power

     2 Do not charge the battery all night