style 1 Wire version MT-04 Red                        style 2 Wire version MT-04 Yellow
 
style 3 Wireless control MT-03 Red                      style 4 Wireless control MT-03 Yellow

Installation Instructions

1、The pressure regulator is placed inside the support bracket， pay attention to alignment screw position (as shown)

2、Use a Phillips screwdriver to four screws were screwed into the four screw holes (left and right side of each 2)

3、Reluctance is placed inside the carriage

4、First a ring and then inserted into a large screw into the corresponding screw holes (Figure)

5、After completion of the large screw through the screw hole at the other end into another ring 2， then screw on the nut (Figure)

6、Use two wrenches tighten the screw clockwise respectively (Note: the screw head corresponding 15mm wrench， 13mm wrench nut correspondence)

7、Tighten the screws and nuts to seamless (pictured)

8、The pressure regulator inside the large screw into the alloy magnetoresistive top column (Figure)

Usage Guide

1. Expand the riding station， open the retaining clips press about four feet (red circle out)

2， the rear axle quick release lever into the bike ride dedicated quick-release lever

3， the pressure regulator is adjusted to a lower position (counterclockwise adjustment)

4， the left side of the rear axle on the left side of the desk hung riding bayonet

5， the right side into the right side of the rear axle and ride station closed bayonet mount (pictured)

6， left and right sides are locked after confirming stable， will lock rotary handle is turned to snapping Bench Division (red box below) after which the two rotary handle this side are no longer tune

7， tighten the pressure regulator， so that contact with the tire (the pressure regulator directly determines the size of the elastic resistance of the riding station)

8， wire installation: handlebar remote control device anywhere， remote control can only be installed on the pipe diameter ≤3cm

9， the front pad: the bicycle front wheel on the front pad effectively prevent inadvertent swing direction when riding a bike station uses (some models riding non-standard units)