This item is fit for:
1999-2005 Buick LeSabre
1999-2005 Buick Park Avenue
1999-2004 Buick Regal
1999 Buick Riviera
1999-2002 Chevrolet Camaro 3.8 Liters
2000-2005 Chevrolet Impala 3.8 Liters
1999 Chevrolet Lumina 3.8 Liters
1999-2005 Chevrolet Monte Carlo 3.8 Liters
1999 Oldsmobile Delta 88
1999 Oldsmobile Intrigue 3.8 Liters
1999 Oldsmobile LSS
2004-2005 Pontiac Bonneville 3.8 Liters
1999-2003 Pontiac Bonneville
1999-2002 Pontiac Firebird 3.8 Liters
1999-2003 Pontiac Grand Prix 3.8 Liters
How to Install a Mass Airflow Sensor:
The mass air flow sensor is designed to measure the amount of air entering the engine from the air filter.It sends the information to the car's engine control unit,which in turn determines the amount of fuel and spark that goes into the engine.A broken mass air flow sensor can possibly cause a wide range of various vehicle drive ability problems such as stalling,especially when the engine is cold,misfiring,poor acceleration,etc.This article deals with the air flow sensor for a 2008 Scion xB, but the process is similar for other vehicles.
Instructions:
1.Open the hood and locate the mass air flow sensor.It should be located just to the left of the air box-where the air filter is located-on the air intake tube.There is a small harness plugging into it,and the wiring for the harness is clipped into the air box.Pull the wiring out of the clip.
2.Unclip the mass air flow sensor from the wiring harness.Using either a Phillips/Torx screwdriver or unscrew the screws and carefully remove the MAF.
3.Carefully place the replacement mass air flow sensor into the intake tube,orienting the MAFback in the same direction as the original one.Screw it in place and Plug the wiring harness back in place and then push the wiring into the clip on the air box.
Attention:Orders from outside US,will be shipped from China!
