Eliminates need to change collets when swapping between bit sizes
One chuck fits bits with shank sizes 3/32'', 1/8'' and up to 5/32''
Twist-to-tighten/loosen with heavily-knurled grip means no wrench or key needed
Fits Dremel and other-brand rotary tools with 9/32'' (7.5mm) fine-threaded spindle
Heat treated & tempered high-carbon steel for durability; rust-resistant black oxide finish

Technical Details

Product Details

Product Dimensions

Package Dimensions
Width : 0.7 inch
Height : 0.5 inch
Length : 1.2 inch

Item Weight: 0.96 ounce (View shipping rates and policies)
Shipping Weight: 1.6 ounce (View shipping rates and policies)

ASIN : B0047WPAMU

Product Description

Any handyman who''s been on his hands and knees looking for a dropped collet will appreciate the beauty of this accessory - because it eliminates the need to change (or lose) collets when you move from 3/32'' to 1/8'' bits or vice-versa. Spring-loaded 3-finger jaw produces secure, even hold on bit shank as you turn chuck down the spindle. For some rotary tools, removing cosmetic nose cap from spindle end will increase tightening range for smaller bits. Excellent quality; made in Taiwan.