Features

Technical parameters

Working pressure: 2-5 PSI (15 kpa)

The atmospheric flow: 15 m2/10 min

Motor speed: 32000 RPM

Operating voltage: 110/230 v - 240 - v (electricity)

Rated power: 650 w

Nozzle diameter: 2.0 MM

Watering can capacity: 800 ml

68 dB noise value: (if the household vacuum cleaner sound size)

The hose length: 1.5 m

Net weight: 2.0 KG (plus 3 KG package to calculate the postage)

Specifications

1. The main purpose

This machine is mainly used in automobile, furniture, equipment, instruments, hotel decoration, house decoration painting

2. Method of use

Before use, connect the pipe with guns and motors. Through the gas regulator to adjust the volume. To reduce the volume must be clockwise, counterclockwise to increase volume. Turn on the motor power supply, make the motor light is located in the open position. Air-pressure machine began to work, drive current. Shut off the power, make the light is in a close parallel state, the motor stop working.

Principle of machine is produced by motor at high speed wind pressure, by the pneumatic hose connection gun to spray gun to carry on the work, motor through the cooling fan in the job, so the temperature will be a little high (about 45 degrees), but after reaching a certain temperature the machine won't rise.

In addition: spray gun, can also be used as a hair dryer oh (such as: computer dust). In front of the house of the small garden, small garden spray can also oh! The real utility!

In order to get the best spray gun spray paint effect, should be:

1. The painting surface clean.

2. Use the right thickness of the liquid.

Preparation of paint:

In order to have the best spray effect, need to use paint to adjust to a certain viscosity. Adjustment method: with random attached quantity, will need to use the paint bucket filled with quantity. Pay attention to its emptying time is 15 to 25 seconds. If the time is more than 25 seconds, the paint is too thick, the paint should be thin. Will need to use paint to paint in the dosing tank emptying time in 15 to 25 seconds, just can use.

3. Based on the graphic operation method of 1-7 installation ready for operation.

4. Adjust the spray gun spray:

A. Around a rotating spray size regulator can adjust the size of the spray state.

B. when used according to the counterclockwise rotation spray size regulator to maximum.

C. Press the power switch on the electric gun, electric spray gun to spray after a few seconds

D. clockwise rotating spray size regulator, the state of fog to adjust to what you need

1, air ratio, coating of each nozzle hole and needle valve please don't damage.

2, each part of immersed in diluent cleaning with the brush cleaning, do not immerse the gun in the entire in diluent.

In the channel

3, cleaning coating spray a small amount of thinner, please.

4, please carefully when disassembling parts cleaning, do not make rubbish are attached above.

5, with needle valve gasket components, in order not to make the needle valve sealing screw twist too tight, please pull the trigger and tight, make flexible needle valve movement.

In order to have a good coating effect, you must correct the operation of the spray gun, when using holding gun spraying surface to keep vertical and parallel to the move, the action must trigger before the start, end to relax before the trigger, so you can correct control lance and coating.

Spray gun and spraying on the surface of the distance should be at 150 mm - 200 - mm, depending on the paint and spray pressure and the working needs. Coating preservation must always maintain appropriate viscosity and even without precipitation, every time when spraying must be tightly attached to the appropriate overlap consistent spraying effect can be attained.