1 x Gimbal 1 x Power cable 1 x Control line (18cm) 1 x Cable tie for camera 1 x Chinese user manual 4 x Screws
Suitable for Xiaoyi camera; Suitable for Cheerson CX20、 Wltoys V303、 DJI Phantom and other aircraft models with 300mm wheelbase Power supply: 11~13V Control panel: the latest BGC3.15 control panel and the most stable 2.2b cracked firmware、 maximum peak current: 10A Prepared port for the third axis control panel、 convenient for expanding The smallest sensor board、 lighter、 smaller and higher precision、 equipped with soft silicone wire Consists of control circuit、 brushless motor and camera holder; Adjustment free、 only need to adjust the center of gravity and power it、 convenient to use; Keep it still for 10s after powering、 then it can work normally Note: Do not connect the yellow control line to the positive pole of receiver、 otherwise、 the control chip will burn out Dimensions: 3.66 in x 3.23 in x 3.15 in (9.3 cm x 8.2 cm x 8.0 cm) Weight: 7.48 oz (212 g)